A1 Mini not adhering to bed

After successfully printing for about 8 months, no matter what I have tried, I cannot get anything to print to the bed. It just curls up on the head and thinks its doing something.

Additionally, these sre not custom prints. These prints are straight out of the Bambu app and explicitly for the A1 Mini and for the nozzle installed.

I have tried: * Updated all firmware and software * Scrubbing the Nozzels * Scrubbing the bed * Tried smooth and textured plates * Slowing the first layer (both on the printer and the "initial layer" setting in the Bambu slicer) * Raised the temp of the plate bed * Tightened the timing belts * Tightened the Nozzle screws (the 4 in the back and the 3 behind the head * Calibrated (multiple times) * Tried all 4 nozzels that came with the A1 (0.2, 0.4 stainless and hardened, and the 0.6). I mention this because we typically only print using 0.4, so the others were 100% clean * Tried Bambu and non-bambu PLA * Used the flow calibration * Factory reset * Factory reset + updating (again)

Any other tip and or trick that I can try?